|
parts for pc3000-pci
dvd disc for pc3000 system
intel 845gv motherboard
north bridge chip: 845GV SL8DA or SL6PT
south bridge chip: FW82801DB SL6DM
assemble CPU (p4 or c4 478pin up to
2.66g 533Mhz) and
RAM (ddr266/333/400 256M-1G)
assemble pc3000 pci card
USB
COM
cable connect COM port, must connect well
insert 2pcs usbkey
don't plug any other card on the motherboard, include the lan card
maxtor 80gb for pc3000 system, put hdd on
IDE2, DVD-ROM on IDE1
v2.4 system supported hard drive:
maxtor 40gb 4D040H2 Code: DAH017K0
(DSP chip)
maxtor 80gb 6Y080L0 Code: YAR41BW0 (SN: Y2 head)
boot from cd
choose "2", enter
choose "2", write FW to hdd
choose "CALIPSO", enter
choose "Standard mode", enter
choose "Disc firmware zone", enter
choose "Work with SA", enter
choose "Writing module", enter
select all, enter
write module, press "space" to yes, enter
if show error #22, write module again and it would be ok.
then turn off power and reboot. every Maxtor hdd needs write FW
only once.
boot from cd and choose "4", make pc3000 system for hdd
choose "local--disk--from image", enter
open "GHOST80E.GHO"
ghost "GHOST80E.GHO" to the hdd, it has two partitions
start to ghost
ghost finish, reboot from hdd
choose "1", the system reboot, and a red lamp on the
pci card would light, if not light means the cable not connected
well.
install the driver of pci3000, and sometimes need to install
driver of usbkey
win xp english version
click "pc-3000", it is ok.
choose "2" to run win2000 pro
win2000 pro, install the driver of pc-3000 pci
click "pc-3000" to run data extractor v2.2. it is ok.
if show the above error, pls check the cable connect from pci
card to the computer com port.
for winxp system, if the cable connect from pci card to computer
com port well, the red lamp would light. for win2000 pro system,
it is a yellow lamp.
if show the above error, means the motherboard or hdd is not
supported by the pc3000 system. pls check if the motherboard is
intel 845gv, and if the hdd is maxtor 6Y080L0 and write FW
rightly.
some times the first time to run winxp, it shows "please insert
the USB-Key", that means the driver of usbkey not installed, pls
click "cancel" or "Logon" till into the system, then install the usbkey's
driver.
|
